Dimensional Calibration
WHAT WE DO
Whether you need to measure length, width or mass, Trescal provides full mechanical and dimensional calibration services which cover every piece of equipment from caliper, micrometer to gauge blocks. We provide full services ISO/IEC 17025 accredited at our laboratory and non-accredited onsite.
Certified qualitythanks to our ISO 17025 accredited calibration laboratories
Minimal downtimewith our onsite services and fast turnaround time
Traceable calibrations to the international system of units (SI)
Complete certificates available 24/7 via your dedicated customer platform
EQUIPMENT TYPES & CALIBRATION SCOPE
EQUIPMENT TYPES
We calibrate numerous mechanical and dimensional instruments including, but not limited to:
- Calipers (digital / analog)
- Dial gauge lever type
- Dial gauge (digital / analogue)
- Plane gauge (external length)
- Plan ring (inside length / diameter)
- Thread gauge
- Thread ring gauge
- Setting standard
- Gauge blocks (comparison)
CALIBRATION SCOPE
- Gauge blocks (steel), accredited: up to 100 mm
- Gauge block, non-accredited: up to 1000 mm
- Caliper, accredited: up to 1000 mm
- Micrometer, accredited: up to 500 mm
- Dial gauge, accredited: up to 100 mm
- Setting standard, accredited: up to 1000 mm
ACCREDITATIONS
ISO/IEC 17025
CAL009
COMMON MANUFACTURERS & MODELS
MITUTOYO (CD-20CP, 209-601, LH600, 183-107…)
TESA (Interrapid, CDL-20B, Micro-Hite,…)
Hoffmann (7220-30, 486000M5, 453500…)
STARRETT (C27030, 3025-481, 254, 226S…)
MAHR (800SG, CX1, Marsurf PS1, IP67…)
Trimos (TV500, 981-20, HPD500, V4…)
